The PRO3200 professional series family of access control modules is
designed for high density installations. Supporting up to 16
readers per enclosure and 32 readers per intelligent controller
along with up to 100,000 card capacity provides a combination of
small installation footprint and superior cost per door ratio.
The PRO22R1 provides I/O support for one card access reader, while
the PRO32R2 supports two card access readers. Both interface with
the intelligent control module (PRO32IC). In the event that
communication to the intelligent control module is lost, the card
access readers can be individually configured to allow entrance
based on security needs. This customization allows for a door to be
configured as locked, unlocked, or access only via valid facility
code.
The PRO32OUT interfaces with the intelligent control module
(PRO32IC) providing up to 12 or 16, Form C, 12 VDC, 2A relay output
controls depending if the board is rack or tile-mounted and power
fail and panel tamper when tile mounted. Relays may be used for
elevator control, status annunciation and for general facility
control, such as door monitoring.
The PRO32IN interfaces with the intelligent control module
(PRO32IC) providing 16 supervised alarm inputs and a dedicated
power fail and panel tamper when tile mounted. An analog to digital
converter samples the input values and the digitized result is
filtered and processed. Filter parameters are configurable for each
input point, resulting in the ability to specify a custom
End-Of-Line (EOL) resistance value, sensitivity range and timing
parameter.
The PRO3200 Series of access modules are designed to accommodate
various mounting options. Units can be mounted in a rack
configuration (PRO22ENC1, PRO22ENC2 and PRO22ENC5) when space is
limited, or in a tile-mount configuration (PRO22ENC3).
The PRO22ENC1 is a wall-mounted enclosure rack unit
The PRO22ENC2 is a 19" rack-mounted enclosure rack unit
The PRO22ENC5 is a rack unit which fits inside a customer’s
enclosure
Modular design fits a wide variety of applications
Up to 9 modules, power-supply and battery can be accommodated by
the PRO22ENC1, PRO22ENC2 and PRO22ENC5 (no battery) enclosures
User programmable relay outputs allow for specific control needs
User programmable alarm inputs offer flexible system configuration
and control
RS485 communication to all modules
Analog to digital converter technology provides digital filtering
and input conditioning
Dedicated cabinet tamper and power monitor inputs
Supports the choice of normally open, normally closed, supervised,
and nonsupervised circuits
Supports a wide range of reader technologies including Wiegand,
magnetic stripe, proximity, and keypad
System off-line modes customizable per reader include facility code
access, locked (no access), and unlocked (full access)
Supports multiple reader and card formats for maximum flexibility
and security options
Operating modes include locked, unlocked, facility code, card only,
card and PIN, card or PIN and PIN only
Communication to the host is via either 10/100 Ethernet or RS-232
(both are standard)
Alarm circuit type - normally open, normally closed,
non-supervised, supervised (with correct EOL). Meets requirements
for UL294 and CUL
Any combination of 16 I/0 or readers modules may be connected to
the PRO32IC RS485 ports. 4,000 ft (1,250 m) total bus length per
port
Supports over 50,000 cards and 50,000 transactions
